I needed timed control over a high powered led, so in my typical overkill fashion instead of just using a simple timer switch, I decided to use an arduino. The overall system consists of 3 parts. A box with the arduino and LED driver, a lightswitch, and an LED mounted on an outrageously large heatsink.
The sketch checks if the switch is on, and while it is, keeps the light on for an hour. After that hour, if the switch hasn’t been switched off (that starts the process over) it dims the light for 5 seconds, then shuts it off. I gave it a 5 second buffer so if one were still in the room they would have time to get back to the switch before the room plunged into darkness.
The one major quirk was that the LED driver I was using needs the opposite of what you would think to turn the led on and off. 5 volts to turn the led off, and 0 volts for fully on. If you look at the code, since I figured that would not be the case for most lights, I added a variable you can change to either have 5 volts be on or off for the led/light controller.
The other major nuisance was that the LED got really hot, really fast. I didn’t have much time, so I just threw the smallest heatsink I had that could handle the heat on the led.
I recently got a good deal on 2 nerf longstrike cs-6s, so I am going to try to make one select-fire. In the mean time however, I found the adjustable stock pretty inadequate. It is either all the way out:
or all the way in:
When it is out, it has a good length of pull, but is longer than it needs to be. When it is in, you can’t get you hand on the grip very comfortably. To over come this, I dismantled the blaster, and found that what locks the stock into those two positions is just a hole drilled into the back of the blaster that a little tab pops into. All you need to do to fix the problem is drill another hole of the same diameter in between the existing ones:
you then have a shorter length of pull but enough room for your trigger hand:
I decided I needed a better trap for my nerf gun, so i built this. Also, to test it out i smashed through a can. The backstop works perfectly!
Here is a video of the nerf gun in action
This is a project I have actually been working on for a while now, but since I finally started this blog I figured I should start posting about it. The original goal was to make the highest powered and most accurate nerf gun that I could. I realized that because I was using nerf darts, the accuracy part was out the window, so i just went with highest power. In its current configuration, with the compressor I have access to, it can shoot a dart through 10 layers of corrugated cardboard and a heavy duty sheet. This is at 150 psi. the valves I am using are rated up to 600 psi, and most of the tubing is rated to around 3,500 psi. I am hoping to soon get a paintball co2 tank and regulator so I can find out the guns full potential. My new goal is to make a nerf dart break the sound barrier.